spacer
injection nozzle

Injection Nozzles


NEW - Mixing Nozzles

Promix Static Mixers further enhance the performance of our extruder and injection screws, and can be used to improve performance when it is not practical to replace the screw. Benefits include improved surface appearance, no colour streaks or flow lines, reduced cycle times and masterbatch savings. Read more ..


Spring Shut Off Nozzles

Spring actuated needle shut-off nozzles are generally used when processing low viscosity thermoplastics or when you want to run the screw (dosing/metering) while the mould is opening. Read more ..


Lever Shut Off Nozzles

Power actuated needle shut-off nozzles are generally used when processing low viscosity thermoplastics or when you want to run the screw (dosing/metering) while the mould is opening. Read more ..


Melt Filter Nozzles

A melt filter is commonly used to protect the hot runner system or when processing regrind or contaminated plastic. Read more ..


Heat Conducting Nozzles

Heat conducting nozzles are typically used on moulds that have small diameter recessed sprue bushings. They offer optimum heat distribution up to the nozzle tip and require neither additional heater bands nor thermocouples in the mould well area. Read more ..


Open Nozzles

As well as supplying special purpose shut off, filter and mixing nozzles we also supply a variety of open nozzles. These include water cooled assemblies for LSR applications and also ‘continuous taper’ end caps and nozzles for properly processing PVC and PC resins. Read more ..